1. Comply with the general operating procedures of casting equipment.
2, it must be observed before work:
A. Check the piping system for air and water leakage. If this happens, notify the maintenance personnel to repair it.
B. Check if the cleaning fluid is sufficient, if not enough, increase the cleaning fluid in time.
C. Start the test run first, and then run it idling for 2-3 minutes, check the transmission system (electrical 1, follow the general operating rules of casting equipment.
This article is provided by the Machinery Knowledge Network, please pay attention to the content provided by the Machinery Knowledge Network
2, it must be observed before work:
A. Check the piping system for air and water leakage. If this happens, notify the maintenance personnel to repair it.
B. Check if the cleaning fluid is sufficient, if not enough, increase the cleaning fluid in time.
C. Start the test run first, and then dry it for 2-3 minutes. Check whether the transmission system (motor, coupling, reducer) and the conveyor belt move smoothly. After confirming that everything is normal, production can be started.
This article is provided by the Machinery Knowledge Network, please pay attention to the content provided by the Machinery Knowledge Network
3. It must also be observed during work:
A. The cleaned parts should be neatly placed on the conveyor belt and not allowed to press on the rollers;
B. On the conveyor belt, the cleaned parts should not be piled too much, so as not to affect the cleaning effect.
C. After work, the cleaned parts cannot be parked on the conveyor belt.