Safety operation process of precision stamping die
<1> . raise the precision stamping die car to the height of the corresponding die on the die holder, and two people pull the die onto the die car at the same time. When the distance between the die car and the die frame is too large, and the die plate surface is lower than the mold seat on the rack, the mold is easy to drop when pulling. The flat surface of the die is too high, and it is not easy to pull the die onto the die car. When the distance between the die car and the die frame is too close, the die wheel is easy to break the guide plate or material support plate at the bottom die feed port.
<2> The precision stamping die should be located in the center of the die car. It is strictly forbidden to use the die car with the increased inclination of the flat surface to prevent the die from sliding off the die car.
<3> After the precision stamping die is pulled onto the die car, the die car shall be pulled away from the die frame for a certain distance, and then the height of the die car shall be reduced to the minimum, so as to prevent other molds or die parts from being broken, crushed and scratched.
<4> During the pulling process of precision stamping die car, personnel are forbidden to play on the die car. The pulling speed should not be too fast to prevent the mold from falling out of the mold car due to inertial force when the mold car turns, causing mold damage or personnel injury.
<5> When pulling the precision metal stamping die car, the force should be slowly pulled. If the instantaneous tension is too large, it will lead to the fracture of the fixing screw at the bottom of the handrail or the armrest of the mold truck.